En-3
Fig. 1 Indoor Unit
1
Operating Control Panel (Fig. 2)
2
MANUAL AUTO button
3
Remote Control Signal Receiver
4
Indicator Lamps (Fig. 3)
5
OPERATION Indicator Lamp (red)
6
TIMER Indicator Lamp (green)
●
If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(See Page 13 Auto Restart).
7
SUPER QUIET Indicator Lamp (green)
8
SWING Indicator Lamp (orange)
9
Intake Grille (Fig. 4)
0
Air Filter
A
Air Flow Direction Louver
B
Right-Left Louver
(behind Air Flow Direction Louver)
C
Drain Hose
D
Power Supply Plug
E
Power Supply Cord
F
Air Cleaning Filter (optional)
Fig. 5 Outdoor Unit
G
Intake Port
H
Outlet Port
I
Pipe Unit
J
Drain port (bottom)
NAME OF PARTS
●
Refer to the folded out page on the cover.
Fig. 6 Remote Controller
K
SLEEP button
L
MASTER CONTROL button
M
SET TEMP./SET TIME buttons (
)
N
Signal Transmitter
O
TIME ADJUST button
P
SET TIMER button
Q
FAN CONTROL button
R
START/STOP button
S
SET button
T
SWING button
U
ACL button
(located inside battery compartment)
Rear Side (Fig.7)
V
TEST RUN button
●
Touch the two metal contacts with a me-
tallic object to send the signal to perform
a test run.
●
Perform a test run only when installing the
air conditioner. If the signal to perform a
test run is received during normal opera-
tion, the air conditioner’s thermostat will
malfunction.
●
If the signal to perform a test run is re-
ceived during normal operation, the unit
will switch to the test operation mode and
the indoor unit’s OPERATION and TIMER
indicator lamps will flash simultaneously.
●
To stop the test operation mode, press the
START/STOP button to stop the air condi-
tioner.
W
Remote Controller Display (Fig. 8)
X
Transmit Indicator
Y
Operating Mode Display
Z
Timer Mode Display
[
Fan Speed Display
\
Clook Display
]
Temperature Set Display
`
Timer Set Indicator
a
Temperature Set Indicator
