4
NAME OF PARTS
Fig. 6 Remote Control Unit
J
SLEEP button
K
MASTER CONTROL button
L
SET TEMP. button (
/
)
M
Signal Transmitter
N
TIMER MODE button
O
TIMER SET (
/
) button
P
FAN CONTROL button
Q
START/STOP button
R
SET button
S
SWING button
T
RESET button
U
TEST RUN button
●
This button is used when installing the
conditioner, and should not be used un-
der normal conditions, as it will cause the
air conditioner’s thermostat function to op-
erate incorrectly.
●
If this button is pressed during normal op-
eration, the unit will switch to test opera-
tion mode, and the Indoor Unit’s OPERA-
TION Indicator Lamp and TIMER Indicator
Lamp will begin to flash simultaneously.
●
To stop the test operation mode, press the
START/STOP button to stop the air condi-
tioner.
V
CLOCK ADJUST button
W
Remote Control Unit Display (Fig. 7)
X
Transmit Indicator
Y
Clock Display
Z
Operating Mode Display
[
Timer Mode Display
\
Fan Speed Display
\
Temperature SET Display
`
SLEEP Display
a
SWING Display
Fig. 1 Indoor Unit
1
Operating Control Panel (Fig. 2)
2
MANUAL AUTO button
3
Remote Control Signal Receiver
4
Indicator Lamps (Fig. 3)
5
OPERATION Indicator Lamp (red)
6
TIMER Indicator Lamp (green)
●
If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(See Page 15 Auto Restart).
7
SWING Indicator Lamp (orange)
8
Intake Grille (Fig. 4)
9
Air Filter
0
Air Flow Direction Louver
A
Right-Left Louver
(behind Air Flow Direction Louver)
B
Drain Hose
C
Power Supply Plug
D
Power Supply Cord
E
Air Cleaning Filter
Fig. 5 Outdoor Unit
F
Intake Port
G
Outlet Port
H
Pipe Unit
I
Drain port (bottom)
06G362_9331435017-01_En.p65
2006.8.7, 3:18 PM
4
