5
Fig. 1 Indoor Unit
1
Operating Control Panel (Fig. 2)
2
MANUAL AUTO button
3
Remote Control Signal Receiver
4
Indicator Lamps (Fig. 3)
5
OPERATION Indicator Lamp (red)
6
TIMER Indicator Lamp (green)
7
SWING Indicator Lamp (orange)
(VERTICAL SWING)
8
SWING Indicator lamp (orange)
(HORIZONTAL SWING)
●
If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(See Page 16 Auto Restart).
9
Intake Grille (Fig. 4)
0
Air Filter
A
UP/DOWN Air Direction Flaps
B
RIGHT/LEFT Air Direction Louvers
(behind UP/DOWN Air Direction Flaps)
C
Drain Hose
D
Power Supply Plug
E
Power Supply Cord
F
Air Cleaning Filter (optional)
Fig. 5 Outdoor Unit
G
Intake Port
H
Outlet Port
I
Pipe Unit
Fig. 6 Remote Control Unit
J
SLEEP Button
K
MASTER CONTROL Button
L
SET TEMP./SET TIME Buttons (
)
M
Signal Transmitter
N
TIMER Button
O
FAN CONTROL Button
P
START/STOP Button
Q
Battery compartment lid
Inside of the battery compartment lid (Fig. 7)
R
AIR FLOW DIRECTION Button
S
ENERGY SAVE Button
T
CODE CHANGE (Slide Switch)
Switching the remote control unit code.
(Max. 4 units)
U
TIME ADJUST Button
V
TEST RUN Button
●
This button is used when installing the air
conditioner and should not be used under
normal conditions as it will cause the air
conditioner’s thermostat function to oper-
ate incorrectly.
●
If this button is pressed during normal op-
eration, the unit will switch to test opera-
tion mode, and the indoor unit’s OPERA-
TION indicator lamp and TIMER indicator
lamp will begin to flash simultaneously.
●
To stop the test operation mode, either
press the TEST RUN button once again, or
press the START/STOP button to stop the
air conditioner.
W
ACL Button
X
Remote Control Unit Display (Fig. 8)
Y
Transmit Indicator
Z
Clock Display
[
Operating Mode Display
\
Timer Mode Display
]
Fan Speed Display
`
Temperature Set Display
a
Timer Set Indicator
b
Temperature Set Indicator
