En-10
ECONOMY OPERATION
Begin Air Conditioner operation before performing this procedure.
To Use t
h
e ECONOMY Ope
r
at
i
o
n
P
r
ess t
h
e ECONOMY
bu
tto
n.
The ECONOMY indicator Lamp (green) will light.
ECONOMY operation begins.
To Stop t
h
e ECONOMY Ope
r
at
i
o
n
P
r
ess t
h
e ECONOMY
bu
tto
n
a
g
a
in.
The ECONOMY Indicator Lamp (green) will go out.
Normal operation begins.
A
b
o
u
t ECONOMY Ope
r
at
i
o
n
●
When ECONOMY operation mode is operated, the room temperature will be little higher than the set-temp under cooling mode
and lower than set-temp under heating mode. Therefore, the ECONOMY mode is able to save more energy than other normal
mode.
●
In case of single-type, at the maximum output, ECONOMY Operation is approximately 70% of normal air conditioner operation for
cooling and heating.
●
In case of multi-type air conditioner, the ECONOMY operation mode is only available for the set indoor unit.
●
If the room is not cooled (or heated) well during ECONOMY operation, select normal operation.
●
During the monitor period in the AUTO mode, the air conditioner operation will not change to ECONOMY operation even if ECON-
OMY operation is selected by pressing the ECONOMY operation button.
10
°C HEAT OPERATION
To
u
se
10
°C HEAT OPERATION
P
r
ess t
h
e
10
°C HEAT
bu
tto
n
The OPERATION indicator lamp (green) will go out, and the ECONOMY indicator lamp
(green) will light.
To stop
10
°C HEAT OPERATION
P
r
ess t
h
e START
/
STOP
bu
tto
n
Then the OPERATION stops and the ECONOMY indicator lamp (green) will go out.
A
b
o
u
t t
h
e
10
°C HEAT Ope
r
at
i
o
n
• The Heating mode will not operate if the room temperature is high enough.
• The room temperature can be maintained at 10°C by pressing the 10°C HEAT button
so as to prevent the room temperature from falling too far.
• In case of multi-type air conditioner, if other indoor unit is used for heating, the temper-
ature of the room where the “10°C HEAT” function is applied will rise. When using the
“10°C HEAT” function, we recommend all indoor units should be run under the“10°C
HEAT” mode.
While 10°C HEAT OPERATION is in
progress, only the following
operation can be used.
• SET
Indicator Lamp
:Lighting
:OFF
Indicator Lamp
:Lighting
:OFF
9374379453_OM_EN.indd 10
12/3/2010 4:31:06 PM
