Fujitsu ABHG18KRTA, Руководство по обслуживанию

Страница: 280 / 471

3-2. Outdoor unit—No power
Forecast of cause
Power supply failure
External cause
Electrical components defective
Check point 1. Check installation condition
• Is the circuit breaker on or off?
• Check loose or removed connection cable.
→ If abnormal condition is found, correct it by referring to the installation manual or the “DESIGN &
TECHNICAL MANUAL”.
↓
Check point 2. Check external cause at indoor and outdoor (voltage drop or noise)
• Instant drop: Check if there is a large load electric apparatus in the same circuit.
• Momentary power failure: Check if there is a defective contact or leak current in the power sup-
ply circuit.
• Noise: Check if there is any equipment causing harmonic wave near electric line. (Neon bulb or
electric equipment that may cause harmonic wave)
Check the complete insulation of grounding.
↓
Check point 3. Check electrical components
Check the voltage of power supply.
Check if AC 198 to 264 V appears at outdoor unit terminal L—N
→ If no, go to
"Check point 1" and "Check point 2" .
+
-
↓
• Check fuse in main PCB.
If fuse is open, check if the wiring between terminal and main PCB is loose, and replace fuse.
• Check active filter module and in IPM.
If active filter module or IPM is abnormal, replace it. (Refer to transistor PCB in
"Service parts
information" on page 03-83.)
↓
Check point 4. Replace the main PCB
If check point 1 to 3 do not improve the symptom, replace the main PCB.
↓
End
3-2. Outdoor unit—No power
- (03-64) -
3. Troubleshooting without error code
TROUBLESHOOTING TROUBLESHOOTING