Fujitsu Siemens Computers Primergy TX200 S3, Инструкция по настройкам

Страница: 45 / 123

TX200 S3
Options Guide 45
Processors Replacing the heat sink
Ê Apply a small amount of thermal paste to the upper side of the new
processor.
Ê Ensure a thin and even distribution of the thermal paste.
Ê
Place the heat sink on the processor socket (see page 38 ).
Ê
Fasten the heat sink by tightening the four screws in a crossover pattern.
Ê
Standard fans: Reinstall the standard fans (see page 39 ).
Ê
Redundant fans: Reinstall the processor fan holder (see page 40 ).
Ê
Reinstall the heat sink holder (see page 40 ).
Ê Redundant fans: Reinstall the ventilation duct over the system fans (see
page 41 ).
Ê Reinstall the ventilation duct over the main memory (see page 30 ).
Ê Close the server, connect it to the power outlet, and switch it on as described
in the
chapter “Completion” on page 93 ff.
6.3 Replacing the heat sink
Ê
Open the server as described in the chapter “Preparation” on page 19 ff.
Ê
Remove the ventilation duct over the main memory (see page 28 ).
Ê
Standard fans: Remove the standard fans (see page 32 ).
Ê
Redundant fans: Remove the ventilation duct over the system fans (see
page 33 ).
Ê Remove the heat sink holder (see page 33 ).
Ê Redundant fans: Remove the processor fan holder (see page 35 ).
Ê Loosen the four screws on the heat sink socket in a crossover pattern (see
page 43 ).
Ê Loosen the heat sink by turning it back and forth and then lift it out.
Ê Clean the upper side of the processor using a lint-free cloth.
Ê
Remove the protective cover from the new heat sink (see page 37 ).
Ê
Place the heat sink on the processor socket (see page 38 ).
Ê
Fasten the heat sink by tightening the four screws in a crossover pattern.