Before Starting Massage
12
Power ON.
1. Connect the power cord plug with the
receptacle.
2. Power ON.
The power switch is behind the left arm-rest.
After power ON, the LCD in the initial stage
displays the screens as shown on the right side
alternately.
Do not use the massager on other than the
designated voltage.
Do not use the chair when the power cord or its plug
is damaged, or when the receptacle is loosened.
It could electric shock, short circuit or fire.
Check items.
1. Check around the chair.
①
Check to make sure that there is nobody, no pet and nothing ahead and
behind the chair and under the foot-rest.
<Standby position>
Press the
“
START/RESET
”
button to start massage. Then, the foot-rest
automatically comes up at about 55 .
* Be sure to check that there is nothing around.
2. Check the main body itself.
①
Hold up the back pad, and check to make sure
that the cover cloth of the back-rest is not torn
and that there is no tear in any other parts.
*
Should there by any tear, no matter how
small it is, discontinue using the chair
immediately. Disconnect the power cord
plug, and contact your dealer for repair.
②
Check to make sure that none of the power cord,
the Remote Controller cord or any other materials
is pinched in the main body.
③
Check to make sure that there is no damage in
the power cord, Remote Controller cord and
the power cord plug and that nothing of dust
(e.g. pins) is attached to the plug.
④
Before seated on the chair, make sure where
there are the knead balls.
The knead balls are
usually located at
the stored position
(in the innermost at
the lower part of
the back-rest)
When the knead balls are not located at the stored
position, press the
“
START/RESET
”
button.
They move down to the lowest position. Press it
again, and then, they go back to the stored position.
⑤
Before seated on the chair, make sure where
there is the foot-rest.
Do not be seated forcibly with the foot-rest at
the upright position. Such attempt may result
in injury. Press the foot-rest [
▼
] button or the
“
RESET
”
button to lower the foot-rest.
*
Press the
“
RESET
”
button. Then, the
back-rest is also stored.
FOOTREST
RECLINER
RESET
FORWARD
BACK
Stored
position
WARNING
Back pad
Pillow pad
STOR E
