Fuji Xerox DocuPrint CM505 da, Руководство администратора

Страница: 273 / 599

Installation When Using Internet Printing Protocol (IPP)
273
Pr
in
te
r En
vi
ronm
en
t Se
tt
ings
7
Installation When Using Internet Printing Protocol (IPP)
This section describes how to install the machine using Internet Printing Protocol (IPP).
The following shows the reference section for each procedure.
Step 1 Preparations................................................................................................................... 273
Step 2 Configuration on the Machine ...................................................................................... 273
Step 3 Configuration on the Computer .................................................................................... 274
CentreWare Internet Services Setting Items ............................................................................ 274
Note • If the size of print data sent via IPP is larger than the value set in the proxy server, the
machine cannot receive the data. In this case, set a larger value in the proxy server or
change your browser setting not to use the proxy server.
Step 1 Preparations
The following items are required to set up the machine to use Internet Printing Protocol
(IPP).
z
TCP/IP network environment
z
The Driver CD Kit (provided with the machine)
Step 2 Configuration on the Machine
The following describes the configuration procedures to use Internet Printing Protocol
(IPP) on the machine. Enable the IPP port, and then configure TCP/IP settings.
Note • You can configure the settings using CentreWare Internet Services or the Driver CD Kit.
For the items that can be configured using CentreWare Internet Services, refer to "CentreWare Internet
Services Setting Items" (P.274). For information on how to configure the setting using the Driver CD
Kit, refer to the manual contained in the Driver CD Kit.
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator’s user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator’s
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3) Select [Tools] on the [Services Home] screen.
2
Enable the IPP port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [IPP], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close] repeatedly until the [Tools] screen is displayed.