Fuji Xerox DocuPrint 5105 d, Руководство пользователя

Страница: 245 / 419

6.4 Printing Problems
245
The printer does not print. If your computer is connected to the printer via a parallel cable, does your computer support
bi-directional communication?
The printer's bi-directional communication is enabled by default. If bi-directional
communication is not supported by your computer, the printer will not print your job. If this is
the case, disable the bi-directional communication on the control panel and try printing
again.
Refer to
• " [Parallel]" (P. 149)
If the printer is connected to a network, is the IP address of the printer set correctly?
Or, is the data-reception control setting set correctly?
Check the above settings and re-configure them if necessary.
Refer to
• " Setting an IP Address (IPv4)" (P. 37)
• " Setting an IP Address (IPv6)" (P. 40)
• " Controlling Data Reception by IP Address" (P. 329)
The size of the print data of a single print job may exceed the buffer capacity. This may
occur when memory spooling is selected for the buffer setting.
If a single print file exceeds the memory capacity, divide the print file into jobs that are
smaller than the memory capacity.
If there are multiple data files to print, decrease the number of files to be printed at one
time.
Printing is slow. The buffer capacity may be too low. If you are printing a high-resolution document, use
[Allocate Memory] on the control panel to reduce the memory capacity of unused items,
which increases the capacity of the print page buffer.
Increasing the buffer capacity can speed up printing. Adjust buffer capacity in accordance
with the size of the print data.
Also, it is recommended to disable ports that are not being used and allocate memory for
other purposes.
Refer to
• " [Allocate Memory]" (P. 204)
Is [High Resolution] selected for the [Image Quality] setting on the [Image Options] tab of
your print driver? Changing the [Image Quality] setting to [Standard] may improve print
speed.
Refer to
• Online help for the print driver.
Printing may be slow depending on the printing method for TrueType
®
fonts. Change the
printing method under [Specify Font] on the [Advanced] tab of your print driver.
Refer to
• Online help for the print driver.
[Printing...] is displayed even
though there is no print job when
the parallel/USB interface is
being used. Did you turn on your computer after switching on the printer? Press the <Cancel Job> button
to cancel printing.
Note
• Check to make sure that your computer is turned on before switching on the printer.
Image loss occurs in the upper
portion of the page.
Printing does not start from the
desired position on the page. Are the paper guides adjusted properly?
Adjust the paper guides properly.
Refer to
• "4.2 Loading Paper" (P. 127)
Check whether the margins are set correctly on your print driver.
Refer to
• Online help for the print driver.
Symptom Cause/Remedy