Fuji Xerox apeosport-IV 6080, Руководство администратора

Страница: 52 / 705

2 Paper and Other Media
52
P
ape
r a
nd O
the
r M
edia
2
5
Push the tray in gently until it stops.
Important • When pushing the paper tray in, do it slowly. If the tray is pushed with too much force, it
might cause machine malfunctions.
Note • Affix the paper size label to the front of the paper tray.
6
Specify the type of the paper loaded when you have changed the paper type.
For information on how to set the paper types, refer to "Changing the Paper Settings" (P.55).
Changing the Paper Size for Tray 6 (HCF (A4 1 Tray)) (Optional)
The following describes the procedure for changing the paper size for Tray 6 (HCF (A4
1 Tray)) (optional).
1
Pull out the tray until it stops.
Important • While the machine is processing a job, do
not pull out the tray that the job uses.
• Do not add a new stack of paper on top of
the remaining paper in the tray to prevent
paper jams or any other troubles. First,
remove the remaining paper from the
tray, and then load the new stack of
paper.
2
Remove any paper loaded in the tray.
3
Open the end guide (1) and unscrew the
screw (2). Then remove the guide from the
tray.
4
Insert the small protrusions at the bottom of
the guide into holes corresponding to the paper size (1). Insert a screw into a hole
corresponding to the paper size on the top of the guide and tighten up the screw (2).