Fuji Spray XPC Series, Инструкция по эксплуатации

Страница: 8 / 24

8 17
ACTUAL SPRAYING TECHNIQUES.
The spraygun should be held perpendicular to the surface at all times.
HOLD THE GUN NO MORE THAN 8” (20cm) AWAY FROM THE SURFACE
TO BE PAINTED. But closer is ok.
CORRECT METHOD
Start moving the spraygun in the direction you want to spray and press the
trigger. Between each successive pass, overlap by about a quarter.
INCORRECT METHOD
PRESSURE POT USE FOR 4-STAGE OR 5-STAGE TURBINE
If you use a 4-stage Turbine or higher, a compressor is NOT needed to
pressurize the Fuji Spray 2 Qt. Pressure Pot.
The Fuji Spray 2 Qt. Pressure Pot Assembly 5432 has unique features. These
features combined with additional pressure from the Fuji Spray 4-stage
Turbine, allows the user to connect the larger capacity pot to the Turbine
system without the need for a compressor.
To connect the Fuji Spray 2Qt. Pressure Pot Assembly, remove the cup
assembly and the pressurizing tube 2024 from the spraygun.
For XPC - Connect your material line (fluid hose) to the fluid coupler 8005 on
the gun.
For GXPC – You will need to order an additional L-Fitting 9060. Attach this L-
Fitting to the G-Fluid Coupler 9051 and connect your material line (fluid hose)
to the other end of the L-Fitting.
You must block off the air that would normally go from the gun to the cup
assembly. This nipple can be covered with Nipple Cap 5411.
PRESSURE POT USE FOR 3-STAGE
If you use a 3-stage Turbine or lower, a compressor IS NEEDED TO
PRESSURIZE THE POT.
PLEASE NOTE: The Fuji Spray 2 Qt. Pressure Pot Assembly 5432 has been
designed for Turbine use and is NOT compatible with a compressor. However,
you are able to hook up a standard 2Qt. Pressure Pot with a compressor.
To connect to a Pressure Pot, remove the cup assembly and the pressurizing
tube 2024 from the spraygun.
For XPC - Connect your material line (fluid hose) to the fluid coupler 8005 on
the gun.
For GXPC – You will need to order an additional L-Fitting 9060. Attach this L-
fitting to the G-Fluid Coupler 9051 and connect your material line (fluid hose)
to the other end of the L-Fitting.
You must block off the air that would normally go from the gun to the cup
assembly. This nipple can be capped with Nipple Cap 5411.
If using a 2-stage or 3-stage Turbine, we recommend the use of a compressor.
Set the compressor to between 6-8 PSI. This is enough to push the paint
material up to the gun. For spraying at greater heights (over 8 feet), more fluid
pressure may be necessary. The fluid pressure should never be set at more
than 20 PSI. If you find a higher pressure is needed, we advise you to check
the material hose for paint blockage.
Never, for any reason, point the spraygun directly at the face, or head of
a person
.