26
INZ-TN3ZRE-E
0DQXDOUDQJHVZLWFK
7KHUDQJHRIWKHPHDVXUHGFRPSRQHQWFDQEH
VZLWFKHGPDQXDOO\DVIROORZV
6HOHFW³05´DVUDQJHVZLWFKPRGHDQG
WKHQSUHVVWKH
ENT
key.
0RYHWKHKLJKOLJKWRIWKHFXUVRUWRUDQJH
VHOHFWLRQDQGWKHQVHOHFWDGHVLUHGUDQJH
E\SUHVVLQJWKH
RUWKH
key. (The
PDUNLQGLFDWHVWKHFXUUHQWO\VHOHFWHG
range.)
7KHQSUHVVWKH
ENT
NH\DQGWKHPHDVXUH
-
PHQWLVFDUULHGRXWLQWKHVHOHFWHGUDQJH
Note) If “RR” or “AR” is selected as range
switch mode, this operation cannot
be performed.
The range for O
2
correction value,
O
2
correction average value, and
O
2
average value is automatically
switched if corresponding instanta-
neous value range is switched.
(Same as for “RR” or “AR”.)
(
)
ENT
ENT
Press the key to end the setting of range
switch mode or range switch operation or stop
the operation in the middle. The setting
operation is made invalid and the previous
screen appears.
To close the setting
ESC
The range identification contact output corresponding to each Ch (component) is conductive
when Range 1 is selected, and open when Range 2 is selected, which is applicable to any of
the range switch mode selected.
Note that even if the range is switched during the hold of measurement value by remote hold
contact input or the hold of measurement value at the time of calibration, the range identifica-
tion contact output maintains the contact state immediately before the hold. After the hold is
canceled, the contact state of the current range is resumed.
Range identification contact operation
(QGRI5DQJH6ZLWFK
