FuelTech FTSPARK 1500mJ, Руководство пользователя

Страница: 25 / 44

25
FTSPARK
2
1
3
6.5 Energy level selection
Energy level may be selected by two ways: ENERGY LEVEL input ground
trigger (pin 9, yellow cable), or through CAN network (values are set in the
ECU’s ignition energy table).
WARNING
When the CAN network is disconnected, the user loses the option
of selecting the energy level through the MAP and visualizing all the
diagnostics and measures that the ignition module is capable of
performing.
Through the diagnostic panel it’s possible to identify if the FTSPARK
is connected. If it’s not connected, product will operate normally (with
energy set by the energy setting wire).
IMPORTANT
In order to run on 750mJ of energy when not connected to a FuelTech
ECU through CAN network, the Energy level selection wire (pin #9 -
yellow wire) must be connected to the battery negative.
If this wire is not connected, the FTSPARK will run on 400mJ only.
Operation without CAN network
Select energy level through ENERGY LEVEL input:
-
400 mJ: Do not connect ENERGY LEVEL input.
- 750 mJ:
ENERGY LEVEL input must be connected to a ground or auxiliary
output.
- FTSPARK EXTREME: 800mJ minimum to 1500mJ maximum
NOTES
- 750mJ (guaranteed minimum energy, can reach up to 850mJ)
- 1500mJ (guaranteed minimum energy, can reach up to 1700mJ)