3a.
WARNING!
Vehicle’s fuel system may be under pressure!
DO NOT
loosen any fuel connections until relieving all fuel
system pressure. Consult an applicable service manual
for instructions to relieve fuel system pressure safely.
Remove
ALL
Fuel and Fuel Vapors from the fuel tank, to
allow a safe fabrication of the Fuel Tank.
GASOLINE
AND OTHER FUELS ARE FLAMMABLE AND CAN BE
EXPLOSIVE!
This step
CANNOT
be overlooked or
ignored. While in many cases, it may be safe to perform
fabrication while the Fuel Tank remains installed in the
vehicle, it may be recommended to remove the Fuel Tank
from the vehicle prior to proceeding.
3b. Refer to the requirements shown in figures on this sheet
and the next, regarding tank requirements. These include:
Flat top with an accessible area at 4.70” diameter.
This area
MUST HAVE
a good surface finish to seal
the flange against the tank using the supplied gasket.
This flat area can be at an angle or even side of tank if
required.
DO NOT INSTALL ON THE BOTTOM OF
THE TANK!!
Minimum Depth (reference figures) is 8-3/4”.
Maximum Depth (reference figures) is 15-5/8”.
4.70 MINIMUM
TANK FLANGE SIZE
REQUIREMENT
(NOT INCLUDED)
10X HARDWARE
NOT SHOWN:
TANK VENT
5.50 RECOMMENDED
MINIMUM TANK WIDTH
A
A
SECTION B-B
MAXIMUM INSTALLATION HEIGHT
SHOWN ABOVE
15.63 MAXIMUM
TANK DEPTH
10X .20 THRU
EVENLY SPACED
3.31
THRU
4.00
CENTERLINE
FOR SCREWS
B
B
SECTION A-A
MINIMUM INSTALLATION HEIGHT
SHOWN ABOVE
FUEL PUMP
8.75 MINIMUM
TANK DEPTH
TANK MUST BE VENTED!
DO NOT ALLOW A
VACUUM TO FORM
INSIDE TANK!
110021251-1, Rev B Sheet 4 of 8
