20
21
operate outer ring at 9k BTU for indirect heat.
8. Open wood shelf and begin cooking. (wood shelf available on
01 and 02 models only)
WARNING:
Wood shelf must remain open while cooking.
Storage And/Or Non Use
• The gas must be turned off at the liquid propane cylinder when
the gas barbecue is not in use.
• When the gas barbecue is stored indoors, the gas supply must
be DISCONNECTED and the LP cylinder stored outdoors in a
well ventilated space.
• LP cylinder must be stored outdoors in a well ventilated area
out of reach of children. Disconnected LP cylinder must be
stored in a building, garage or other enclosed area.
• When the LP cylinder is not disconnected from the gas barbe-
cue, the appliance and LP tank must be kept outdoors in a well
ventilated space.
• The gas barbecue should be checked for gas leaks and any
obstructions in the burner tubes before using. (See maintenance
section)
Operating
WARNING:
Only use this barbecue outdoors in a well ventilated
area. Do not use in a garage, building, breezeway or any other
enclosed area.
WARNING:
Keep ventilation openings for cylinder enclosure free
and clear from debris.
WARNING:
Your gas barbecue shall not be used under overhead
combustible construction.
Gas Hook-Up
Lp Gas Hook-Up For Type 1 Or Qcc1 Regulator
(Standard with grill):
The Element by grill is orifi ced for use with LP gas and comes
equipped with a high capacity hose and regulator assembly for
connection to a standard 20lb. LP cylinder (Type 1). The LP tank
is not included. LP hose and fi ttings are included. Operating
pressure: 10” W.C.
To connect the LP regulator and hose assembly to the tank/valve
assembly, fi rst make sure the main valve on the tank is completely
closed. Although the fl ow of gas is stopped when the Type 1
system is disconnected as part of its safety feature, you should
always turn off the LP tank main valve (FIG. 01) after each use and
during transport of the tank or
unit. Insert the regulator inlet
into the tank valve and turn the
black coupler clockwise until the
coupler tightens up. Do not over
tighten the coupler. Turn the
main tank valve on and turn the
burner control valve on the unit
to the high position for about 20
seconds to allow the air in the
system to purge, turn valves off
and wait 5 minutes before at-
tempting to light the burners.
To disconnect the coupler, fi rst
make sure the main tank valve
is turned off. Grasp the coupler
and turn counter-clockwise.
The inlet will then disengage,
remove the inlet from the
tank valve opening if it has not
LP regulator
hose assembly
Type 1
regulator
Type 1 Tank
Main
Valve
FIG. 01
