Fubag FB 150, Руководство оператора

Страница: 2 / 11

O m perator's anual
WARNING! BEFORE USING THE WELDING READ THE INSTRUCTION
MANUAL CAREFULLY! FOR QUALIFIED AND SPECIALLY TRAINED PERSONS
ONLY AFTER PROPER READING OF THIS MANUAL IS ALLOWED TO USE AND TO
MAINTAIN THIS WELDING .
TORCH
TORCH
The detailed description, safety rules and all required information necessary for proper operation
and maintenance of FUBAG welding
are provided below. Keep this instruction manual by
and refer to it by any doubts concerning safety operation, maintenance storage and handling of
FUBAG welding
.
torch torch
torch
1. Safety peration o
-
-
-
-
-
-
-
-
-
-
-
-
-
;
;
;
;
It is highly recommended always to follow the safety rules. Wear protective clothes and
special means to avoid injuries to eyes and skins.
Use the welding mask or special protective glasses while working with the welding
machine. Only by viewing through the filter lens on the welding mask your eyes are
secured by your operation.
Prevent the sparks and spatter from harming your body.
Under no circumstance allow any part of your body to touch the welder's output bipolarity
(torch and work piece).
Do not operate under water or more humid place.
Fumes and gases produced when welding are hazardous to health. Make sure to work in
places where there are exhaust or ventilation facilities to keep fumes or emissions away
from the breathing zone.
Please remember to keep arc rays away from the other nearby people when welding. This
is only due to the interference from arc rays.
There will be high temperature when welding work piece, so please don't directly touch on it
No touching on the electrification parts after turning on the power. Cut off the power supply
after operation or before leaving the welding site.
No welding in the dangerous site where easily get an electrical shock.
No welding for the container loaded inflammable or explosive materials.
Safe measures should be adoptted while operating in high place to avoid accident.
No entering the welding site for persons not concerned.
In order to avoid the explosion of the gas bottle:
- make sure that the gas type corresponds to the required
- use faultless hoses and fittings
- place the torch so that there was no contact with the gas bottle
- close the stop valve of the tank when the gas is not used.
:
- it is necessary to shorten the length of welding and ground cables as much as possible;
- the welding cable is to be situated as close to the ground as possible
- the ground cable and the torch cables are to be situated parallel and should not cross.
WARNING
WARNING.
The welder voltage is always higher, so the safety precaution should be taken
before repair to avoid accidental shock. Switch off the power supply before each type of
maintenance work. The untrained people are not allowed to make maintenance of the
. torch
www.fubag.ru
- 1 -