FTS LT1-CELL-VZ, Руководство оператора

Страница: 42 / 66

700- LT1-Man Rev 8 09 Feb 2021 Page 36/60
8) Confirm message format : Confirm message format and data points by viewing an
example of a configured message. Select Show Configured Message. Note that no data is
sent and only simulated values of 1.0 are displayed to illustrate the message format.
Reset: If changes have been made but not saved, selecting Reset will discard those changes and
remain on the same page.
Cancel: If changes have been made but not saved, selecting Cancel will discard those changes and
return to the previous page.
5.4.3 SETTING UP RANDOM TRANSMISSIONS
Random transmissions are SHEF or Pseudo Binary (USGS-PB) transmissions that are made outside
of the scheduled transmission and are sent when an alert condition is detected. Random
transmissions are not supported by BLM message type. Random transmissions are set up from the
Station GOES Settings page and must be set up after the Scheduled Transmissions.
A random transmission will be sent every time an alert condition is detected but not more
frequently than five minutes.
IMPORTANT!:
1) Variables used to trigger an alert in random transmissions should have a minimum
5-minute sample frequency. More frequent sampling of alert variables during an
alert event will result in a data backlog.
2) If using a 5-minute sample rate for an alert variable, the number of retries
should not exceed one (1) to prevent a data backlog
NOTES:
• The random transmission feature will only operate in conjunction with FTS360 Config App
version 1.7.16 and later
•
The number of random transmission retries should not be greater than 1 if using a 5-
minute sample frequency for alert trigger variables to prevent a data backlog.
•
If multiple data points are included in a random transmission, only the trigger data value
will be updated. Other data values will be the previous reading (currently logged values)