Fume hoods
Soldering - Desoldering
Specialized tools for wiring and tinning
Hand tools, consumables and workshop equipment
r
–
+33 (0)1 40 86 00 09
–
www.ftm-technologies.com
3
5. START-UP AND OPERATION
- Check that the switch is in position 0. Check that the temperature control knob is in the minimum position.
- Connect the electrical outlet. Take the clip in hand
- Pinch the workpiece (s) to be soldered.
The spacing of the clamp can be adjusted by unscrewing the 2 screws at the base of it and inserting a small
wedge on each side. Tighten the 2 screws then.
- Switch on the device. Set the temperature control knob to the required temperature.
The operating temperature depends on the section of the parts to be sodered; preliminary tests must be carried
out.
- Press the pedal to start the heating. Bring a piece of tin.
- Once the solder is finished, release the pedal.
To avoid electric shock, always release the pedal before reopening the clamp.
- To stop the heating, turn the switch to position 0. During a long stop, disconnect the power supply.
6. CARE AND MAINTENANCE
Before any intervention, remove the power cord from the power outlet.
Control block: Wipe with a dry cloth.
Pliers: Brush the tip of the electrodes with a wire brush or emery cloth. Regularly change the electrodes.
7. SPARE PARTS, CONSUMABLES
- Fuse 3,15 A
Quantity: 1
For the SI1R
- Electrode set - Ref. ESI1R Quantity: 5 pairs.
- Clamp + cord - Ref: PCSR Quantity: 1
For the SI2R
- Electrode set - Ref. ESI2R Quantity: 3 pairs.
- Clamp + cord - Ref: PCSI2 Quantity: 1
Replacement cord: If the power cord is damaged, it must be replaced by the manufacturer, its after-sales service
or similarly qualified persons in order to avoid danger.
