Section 5
Changing Settings
26
FT702LT/D Flat Front Wind Sensor Manual
Never unplug the wind sensor while the Set Up and Test Program is running as this may
leave the current loop outputs disabled. Always click on the Disconnect button and then
exit the Set-Up and Test Program before unplugging or powering down the FT702LT/D.
The FT702LT/D Set-Up and Test Program cannot be used to configure any other FT Technologies products.
5.3 Change Settings
The settings can be changed on a sensor by using the Settings tab. This will show the current sensor settings
on the left and options that can be changed on the right. Select any new settings required on the right and then
click on the Update Settings button to apply them. The new sensor settings will then be displayed on the left.
Clicking on the Factory Defaults button will cause the settings to be reverted to factory default as per Figure 22
Please Note: Some functionality cannot be set for lower build versions of sensors. For example when an older
build version of the sensor is connected, some features are automatically deactivated and cannot be adjusted.
This is because the features are not available in the sensor.
Figure 24: FT702LT/D Set-Up and Test Program Settings
5.4 Sensor Report
The settings applied to a sensor can be reported using the
Record Settings
button. The following parameters
are then saved into a file every time the
Record Settings
button is clicked.
Serial Number
