HD-H704K-WP Extender
6
Transmitter Panel Description
1. Power LED:
The LED illuminates red when power is applied and is off when no
power is present.
2. Link LED:
The LED illuminates green when there is a valid HDBaseT connection
with the receiver. The LED flashes when there is no valid link.
3.
Built-in IR sensor, receive IR signal sent from IR remote.
4. HDMI In:
Type-A female HDMI input port to connect an HDMI source device.
5. RS232:
3-pin on terminal block to connect the RS232 control device (e.g. PC) or a
third-party device to be controlled by RS232 commands.
6. DC IN
: 2-Pin terminal block, connect with a power supply if powered locally.
7. IR In:
2-pin on terminal block to connect IR receiver or IR system for IR
pass-through.
8. HDBT (PoC):
RJ45 HDBaseT output port to connect to the
HDBT IN
port of the
receiver by a CATx cable. It supports 12V-48V PoC and compatible with 48V PoH.
Note:
STP cable is needed when Transmitter is powered from the Receiver by
PoH.
9. Switch for determining the behavior of the RS232 connection:
RS232:
When in this position, it serves as an RS232 serial Pass-through.
FW Update:
When in this position, it allows you to update the firmware by
connecting to a PC and running the batch file.
