FSR DV-HDSS-41-TX, Руководство пользователя

Страница: 11 / 21

Connection and Installation
1. Using only good quality VGA/DP/HDMI cables firmly connect a 4K or HD
source device to the VGA/DP/HDMI input ports of the switcher.
2. Firmly connect HDMI OUT of the Switcher to HDMI IN of 4K or HD display
devices ensuring both source and display devices are compatible and
correctly configured to output and accept the required signal resolution.
3. Connect a good quality, well-terminated CAT-6A shielded cable between
the HDBaseT OUT of the Transmitter switcher to the HDBT IN Input of an
HDBaseT Receiver.
4. Insert the included power supply, Check the front panel power LED to
indicate the switcher is ready to use.
5. Connect the CONTACT IN, TALLY OUT and SINK via the Male Connector
included.
Note:

External momentary contact closure referenced to GND should
be >1mA but <5 mA.

Open circuit voltage 3.3~12 volts will be acceptable.

Protected against application of external voltages is in the range of
+/- 24V W.R.T. GND.

Minimum contact closure time is 50 ms (It is able to ensure
detection of external closure).

LED output voltage is +12 volts (Nominal, 10~13 volts is acceptable),
maximum output current is 100 mA and when active it should be
short circuit protected.
6. Switch between sources using the switch buttons in front panel, via
CONTACT IN control, or RS232.
7. Switcher can be directly connected to FSR HV-T6 Table Box following
wiring chart below.