7
10/2021
Safety Instructions
On Safety
1. Before connecting the power cord, make sure the voltage designation corresponds to the
local electrical supply.
2. Never insert anything metallic into the cabinet openings of the device. Doing so may create
the danger of electric shock.
3. To reduce the risk of electric shock, do not remove cover. No user-serviceable parts inside.
Only a qualifi ed technician should open the case of the device.
4. Never use the device if the power cord has been damaged. Do not allow anything to rest on the
power cord, and keep the cord away from areas where people can trip over it.
5. Be sure to hold the plug, not the cord,when disconnecting the device power cord from an
electric socket.
6. Unplug the device power cord when it is going to be left unused for an extended period of
time.
7. Unplug the device power cord from the AC outlet before any service.
8. If the device does not operate normally, in particular, if there are any unusual sounds or smells com-
ing from it, unplug it immediately and contact an authorized dealer or service center.
9. Please contact the manufacturer if the set should be installed in an inaccessible area.
Warning:
Do not touch input or output connectors and the patient simultaneously.
Warning:
This device is intended for connection to input/output signal s and other connectors
that comply with relevant IEC standard (e.g.,IEC60950 for IT equipment and IEC60601 series for
medical electrical equipment). In addition, all such combination-system shall comply with the
standard IEC 60601-1-1 or clause 16 of the 3 Ed. of IEC 60601-1, respectively, safety requirements
for medical electrical systems. Any person who has formed a combination-system is responsible
for the system to comply with the requirements of IEC 60601-1-1 or clause 16 of the 3 Ed. of IEC
60601-1, respectively. If in doubt, contact qualifi ed technician or your local representative.
Warning:
To avoid risk of electric shock, this device must only be connected to a supply mains
with protective earth. Power supply is specifi ed as a part of the device. Do not position equip-
ment in such a way that it is diffi
cult to disconnect the power cord plug from the appliance inlet.
Warning:
Do not modify this equipment without authorization of the manufacturer.
Product fuse has a lower breaking capacity. Do not install at the building power system, prospec-
tive short-circuit current exceeding 35 A.
