FSL3D Phoenix Touch, Руководство пользователя

Страница: 34 / 45

34
Exterior Printer Care
● To keep the body of Phoenix clean, use microfiber cloth to wipe the outside. Avoid
products that contain ammonia, e.g. Windex.
● Never clean any part of the exterior or the cover with Isopropyl Alcohol (IPA) since it will
cause permanent damage to the printer.
● Never remove the SuperVAT™ before removing the build head. Remove the build head
first to prevent drips and resin damage to the exterior and interior components of the
printer.
● Occasionally use compressed air to clear dust from vents and fans.
Transportation
To transport the printer, please follow the instructions below.
● Clean excess resin from the build head with paper towels.
● Wrap the build head in plastic wrap and reattach to the printer.
● Clean resin from the SuperVAT™ liner with paper towels. Never use IPA which may
cause cracking. Wrap the liner with plastic and place it back into the printer.
● Lower the build platform by using the motor control. Lower it until the build head touches
the base, securing the vat in place.
● Rebox the printer and accessories in the original package as they were received.
Resin Care
Removing Cured Pieces From Failed Prints
In case of a failed print, you will need to remove cured resin remnants from the SuperVAT™
liner. Lightly run a soft rubber spatula across the bottom surface of the liner to find the pieces
and dislodge them. Tweezers or other devices with sharp edges may damage the SuperVAT™
liner.
Handling
● Please wear protective gloves when handling resin. If you get any on your skin, wash
thoroughly with soap and water immediately. The resin can cause mild skin irritation.
● Never ingest resin nor drink/eat from printed parts.
● Cured resin is safe to touch and handle without gloves or other protection.
[Main Menu]