FScurtis FAC-52B, Инструкция по эксплуатации

Страница: 29 / 63

4.Operation
4-9
4.4.1 Procedure to start the unit

Be sure to let unit warm-up after starting for smooth operation of the engine and the compressor.
Do not operate the engine at full load immediately after it starts up. This will shorten the equipment life.

During the warm-up operation, examine the different parts of the equipment for any looseness, leakage
of water, oil, fuel, and other irregularities.
Also, make sure that monitor lamps are off.
<Procedure>
①
Close fully service valve.
②
Turn the starter switch
“
1
”
to “RUN" position, and the glow lamp
“
2
”
goes on.
③
As soon as the glow lamp
“
2
”
has gone out, turn the starter switch
“
1
”
fully clockwise to start up
the engine. (After starting, unload operation automatically begins.)
(Never hold the key in the “START” position for longer than 15 seconds or the starter motor will
overheat.)
According to engine cooling water temperature, the times in the following table are required.
Engine coolant
temperature
Required time
for preheating
Required time for starting unloader operation
Higher than 0
℃
2 sec 5 sec
Lower than 0
℃
20 sec
Shorter time either 120 seconds or the time when
engine coolant temperature
becomes higher than 0
℃
.
④
Once the engine has started up, leave it running to warm-up for 5 minutes. The discharge air
pressure gauge
“
3
”
in this condition ranges from 0.3 to 0.9MPa.
⑤
After finishing warming up operation, open the service valve provided at the outlet of compressed
air and start service job.
Be sure to warm-up
A110165E
2 3 1