Technical Overview
I. Important Notes
For correct operation of this appliance, it is essential to observe the manufacturer’s instructions.
If this system is to be installed permanently as a POU or POE system,
installation must be carried out by a qualified plumber or authorised
technician to comply with Australian Plumbing Codes.
This system
contains electrical components and plumbing components; Use
caution and if leaking occurs, turn the power off immediately before
conducting maintenance or repair to the system.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the
appliance.
If the supply cord is damaged, it must be replaced by a special cord or
assembly available from the manufacturer or its service agent.
II. Before You Purchase/Open
The system requires specific working conditions to be met before installation, some general guidelines* are
listed below. If these conditions are not met, the system may not be suitable for the application and may not
function as specified.
These systems are designed for filtration on mains water for the removal of minerals, salts and other
impurities. The system may also be used on other sources such as Bore Water however you should
enquire with the supplier before purchasing for any use other than mains water to ensure the system is
correct you the application.
III. Space Requirements
The LSRO Systems are not IP rated and therefore are not suitable for external installation without adequate
weatherproofing or cover from the elements including but not limited to Rain/Moisture & Frost.
The Frame of the system includes mounting holes so the system can be mounded to a wall. It is
recommended that the system be mounted if possible, rather than free-standing as this will help support the
weight of the system when full of water. If necessary, the system is able to also free stand.
System Dimensions
Depth: 20cm
Width: 37 cm
Height: 45cm
If the system is to be enclosed in a cover, allow adequate ventilation around the pumps & power supplies to
prevent overheating.
Feed Water Conditions
Min
Max
Inlet Pressure
350 kPa
700 kPa
Temperature
0.5°C
38°C
pH Level
2
11
TDS
0 mg/L
2,000 mg/L
Iron
0 mg/L
0.3 mg/L
Manganese
0 mg/L
0.1 mg/L
Hardness
0 mg/L
200 mg/L
