12
EN
1. After configuring the stacking, the last two 10G ports will disappear from the configuration file,
which is normal. This design is to prevent misoperation.
2. If using the DAC as the stacking cable, the 1-3m DAC is recommended.
Stacking Configuration Troubleshooting
Configuring the Switch Using the Console Port
Troubleshooting
In the case of compatible cables and transceivers, the port cannot be up, please try to modify the port
mode to adapt or force the port speed to 1G/10G.
10G Port is not Working
Step 1: Connect a computer to the switch's console port using the supplied console cable.
Step 2: Start the terminal simulation software such as HyperTerminal on the computer.
Step 3: Set the parameters of the HyperTerminal: 115200 bits per second, 8 data bits, no parity, 1 stop
bit and no flow control.
Step 4: Enter the default username and password,
admin/admin
.
x
Quick Connect
Protocol:
Serial
Flow Control
DTR/DSR
RTS/CTS
XON/XOFF
Save session
Show quick connect on startup
Open in a tab
Connect
Cancel
COM3
115200
8
None
1
Port:
Baud rate:
Data bits:
Parity:
Stop bits:
Name of pipe:
