Frymaster Super Cascade Filtration Systems CE, Руководство по эксплуатации

Страница: 7 / 13

5
Drain Valve
Handle
Oil Return
Handle
H250 Drain & Oil Return Handles
Air bubbles from the Oil Return Line
b. H250 Fryers:
1. Turn the lower red drain valve handle from left to right to open the drain valve. The photo
below shows the drain valve in the open position.
2. Stir the oil in the frypot with the L-shaped
teflon brush as the oil drains into the filter
pan. Brush down the vessel sides to remove
debris. Use the clean-out rod to clear the drain
if necessary.
3. Open the oil return valve by turning the
smaller red handles located under the frypot.
The oil return handle is located above the
drain valve handle. Push this handle away
from you to open the oil return line. This will
activate the filter pump also.
4. If the circuit breaker kicks out, this often means
that there is an obstruction in the oil return lines.
Note: The filter circuit is protected by a 5-amp circuit breaker located under the control
panel of the filter cabinet. If the circuit breaker trips, the filter pump will stop,
manually reset breaker and continue.
5. Polishing: If desired, the oil can be polished. Leave the fryer drain valve open for
approximately 5 minutes and allow the oil to circulate from the frypot into the filter and
return to the frypot several times before closing the drain valve. The circulating oil will be
cleansed repeatedly and polished by the micro filtering powder. Polishing extends oil life and
improves cooking flavor.
6. Close the fryer drain valve. Turn the lower red drain valve handle from right to left to close
the drain valve. The frypot will begin to fill up with filtered oil.
Note: After filtering it may be necessary to discard filter paper before filtering another fryer.
Replace filter paper when it becomes dark or scuffed in appearance or if refill times
become extended.
7. Allow the filter to pump bubbles into the fryer for
approximately 10-15 seconds to ensure the
evacuation of all oil from the filter pan and the oil
return lines.
8. Turn the filter off by pulling the oil return handle
towards you to close the oil return line. This shuts
down the filter pump motor also.