Frymaster 1814E Series, Руководство по обслуживанию и запасным частям

Страница: 11 / 72

1-6
from the lift springs. Also ensure that the wire sleeving extends into the tube assembly to
prevent the edge of the tube assembly from chafing the wires. Press the pins into the connector
in accordance with the diagram on the following page, and then close the connector to lock the
leads in place.
NOTE: It is critical that the wires be routed through the sleeving to prevent
chafing.
1
4
2
5
3
6
1
4
2
5
3
6
7 8 9
5
R
4R
6
R
1R
2
R
3R
Index Marker marks
Position 1
5L 4L 6L 1L 2L 3L
8. Reconnect the element connector ensuring that the latches lock.
9.
Insert the temperature probe leads into the 12-pin wiring harness connector C-6 (see illustration
below). For full-vat units or the right half of a dual-vat unit, the red lead goes into position 3 and
the white into position 4. For the left half of a dual-vat unit, the red lead goes into position 9 and
the white into position 10.
NOTE: Right and left refer to the fryer as viewed from the rear.
10. Reconnect the 12-pin connector C-6 of the wiring harness disconnected in Step 2.
11.
Lower the element down onto the basket rack.
12.
Reinstall the tilt housing and back panels, reposition the fryer under the exhaust hood, and
reconnect it to the electrical power supply.
1.7 Replacing Contactor Box Components
1. If replacing a contactor box component above the built-in filter system, remove the filter pan and
lid from the unit. Drain the frypots into a Shortening Disposal Unit (SDU) or other appropriate
metal container. If replacing a contactor box component in a non-filter unit or a frypot that’s not
over the filter pan, drain the frypot above the box into a Shortening Disposal Unit (SDU) or other
appropriate metal container.
DANGER
DO NOT drain more than one full frypot or two split frypots into the SDU at one time.