FRONT PANEL FUNCTIONS
FRONT PANEL, LEFT TO RIGHT
1. INPUT
HI
- High sensitivity input (also has a brighter tone)
2. INPUT
LOW
- Low sensitivity input (also has a slightly darker tone)
LEAD CHANNEL CONTROLS
3. LEAD
EDGE
SWITCH
- Frequency dependent gain boost; gain increases as you play up the neck (it’s subtle)
4. LEAD
GAIN
- Amount of overdrive
5. LEAD CHANNEL SWITCH - Activates Lead Gain, Volume and Edge. Overrides Rhythm and Clean channels. Must
be OFF for Rhythm and Clean channel to operate.
6. HI GAIN SWITCH – Gain Stacking Switch. Activates additional tube overdrive gain stage.
7. LEAD
VOLUME
- Activated by LEAD (5) Pre FX loop
RHYTHM CHANNEL CONTROLS
8. RHYTHM
BOOST SWITCH - Switches from low (clean to slightly dirty) to medium gain (crunch to medium overdrive)
9. RHYTHM
GAIN
- Activated by Rhythm (10)
10. RHYTHM CHANNEL SWITCH - Toggles between rhythm and Clean channel
11. RHYTHM VOLUME - Activated by Rhythm (10) Pre FX loop
12. RHYTHM EDGE SWITCH - Same function as Lead Edge for Rhythm channel
SHARED LEAD/RHYTHM CHANNEL CONTROLS
13. TREBLE - Active for both Rhythm and Lead channel
14. SHIFT SWITCH - Active for both Rhythm and Lead channel. Shifts Treble, Middle and Bass shelving down.
15. MIDDLE - Active for both Rhythm and Lead channel
16. BASS - Active for both Rhythm and Lead channel
CLEAN CHANNEL CONTROLS
17. CLEAN VOLUME - Gain and volume for Clean channel, pre FX loop. For initial set-up, set to approximately 2 O’clock
with Master Volume at approximately 2 O’clock and match Rhythm Volume and Lead Volume to desired setting
18. CLEAN BOOST SWITCH - Gain boost for Clean channel
19. TREBLE
20. BRIGHT - High frequency boost (becomes less active as Volume increases)
21. MIDDLE
22. SHIFT SWITCH- Low midrange boost between Middle and Bass frequencies
23. BASS
GLOBAL CONTROLS
24. GRAPHIC EQ – 100Hz, 250 Hz, 630 Hz, 1.2KHz, 2.3KHz, 5KHz
±
12 dB cut or boost per band. Activated by
rear panel pushbutton or footswitch.
25. MASTER VOLUME – Global power amp volume control, post FX loop. Controls volume of all 3 channels.
26.
STANDBY - Turns on high voltage to output section and selects between full-power or half-power
operation.
Standby switch settings: II= Full Power (4 power tubes) ; 0= Standby, I= Half Power (2 power tubes).
27.
MAINS – Switches main AC power on or off.
