5
REAR PANEL
RIGHT TO LEFT
1. INPUT A/MONO BRIDGE - Upper input jack for BRIDGE/MONO signal input. (Example: Mono signal coming from a pre-
amp is sent to A and B Channels simultaneously) or to Channel A input from a stereo source.
2. INPUT B - Lower input jack for Channel B for stereo source operation (example: left and right outputs coming from a stereo
modeling preamp or stereo effect processor would input left signal to Channel A input and right signal to Channel B input).
NOTE!
Sending a single source signal (MONO) into the Channel B input without inputting any signal to the Channel A input
will effectively defeat the operation of Channel A (no sound from Channel A).
3. ENHANCE REMOTE – Footswitch TRS jack for remotely engaging the Presence (tip) and Depth (ring) switches on the front
panel. You can use any standard 2-function TRS latching footswitch or remote switching device. Shielded or non-shielded
cable is suitable for this application. (Footswitch sold separately.)
4. LINE OUT – A line level version of the speaker output sound for connection to a direct box or recording interface.
5.
SPEAKER OUTPUTS A – Two parallel outputs for each channel.
NOTE!
To prevent damage to power tubes and/or output
transformer, ALWAYS USE “
USE
FIRST”
output when running one speaker cab for either or both channels.
6. IMPEDANCE SELECTOR A – Sets optimum operating impedance for each channel. Set for 4, 8, or 16 Ohm loads.
7.
SPEAKER OUTPUTS B - Two parallel outputs for each channel.
NOTE!
To prevent damage to power tubes and/or output
transformer, ALWAYS USE “
USE
FIRST”
output when running one speaker cab for either or both channels.
8. IMPEDANCE SELECTOR B - Sets optimum operating impedance for each channel. Set for 4, 8, or 16 Ohm loads.
9. STEREO/MONO SWITCH – Selects BRIDGE MONO (channel A and B in parallel) mode or Stereo (independent channel
operation) mode.
NOTE! Operating impedance is 2, 4 or 8 ohms in BRIDGE MONO MODE as indicated under the
upper (A Channel) impedance selector switch. NOTE! It is OK to drive a 16 ohm load on the 8 ohm setting in
BRIDGE MONO mode.
10. MAINS FUSE – Protects the amplifier from electrical faults. Replace only with type and rating specified
on the rear panel of your amplifier.
Warning! Replace only with same fuse type and rating.
11. AC MAINS INPUT –
Connect to a grounded outlet in accordance with the voltage and frequency specified on the rear
panel of your amplifier.
Use only the factory supplied cord set or a UL approved equivalent type.
