Copyright 2010 DTX International
8
BEER TOWER INSTALLATION
1
.
To install the beer tower (page 5, L), first, thread the rubber gasket over the
beer line (M) and seat over the notches on the base of the dispenser
assembly so that it lays flat (Figure A).
Note:
While not required, we recom-
mend the use of the black rubber gasket when installing the beer tap. Using
the gasket will provide a more secure seating for the arm assembly (see
figures A, B, C and D).
2.
Next, line up the draft arm notches with the notches in the hole in the top of
the kegerator.
3.
Feed first the beer line (Figure B), then the base of the tower, into the hole,
making sure that the notches are aligned properly.
4.
Slide tower down and twist (Figure C) until it is secure (no screws or fasten-
ers are necessary). The spigot of the beer tower should now be facing the
front of the kegerator.
5.
To complete the beer tower installation, screw on the spigot handle (Figure
D).
Figure A
Figure B
Figure C
KEGERATOR ASSEMBLY
Figure D
GUARDRAIL INSTALLATION
To install the guardrail, first:
1
.
Place the guardrail (page 5, I) atop the kegerator
and line up the guardrail’s feet with the holes on
top of the cabinet.
2.
Pop the guardrail gently into place, taking care
not to scratch the top surface of the kegerator.
DUAL REGULATOR SPECIFICS
