1. Turn the microphone on by sliding the
Power Switch up.
2. Note Power Indicator (chair icon).
Green
= On and transmitting
Off
= Power is off
NOTE:
In order to conserve battery life,
if the power switch is left on, your micro-
phone will automatically go into Standby
Mode (off) after 10 minutes of silence.
Move the switch to the off position, then
back on to reset.
3. Keep the top of the microphone approxi-
mately 3 - 4in. (7.5 – 10cm) from the mouth
when using it as a hand-held microphone.
4. Do not block emitter diodes.
5. To allow hands-free use (for example,
when reading aloud and turning pages),
attach the lavaliere clip and neck strap.
Adjust the neck strap to position the
microphone approximately 4 - 5in (10 -
13cm) from the mouth.
6. When needed, you can simply push and hold
the Power Switch while talking rather than
sliding it into the "on" position. This makes
transitions when passing the microphone
between students easier (e.g., no need to
take time from the conversation to turn the
mic on and off during transition). For best
results, when using the push-to-talk func-
tion, be sure to press on the lower section
of the switch.
7. When the battery in your microphone
gets low (approximately 1/2 hour of
use time left) the battery indicator will
flash red.
8. Turn off the microphone and charge at
the end of the day.
3-4in. (7.5-10cm)
4-5in. (10-13cm)
Power
indicator
Power/
Push-to-talk
switch
Emitter diodes
Battery
indicator
ISM-02L Pass-Around Microphone
Using
8
