background image

www.frontlinefall.com

INTRODUCTION:-

debris, rot, decay, cracking, and hazardous materials.

Thank you for purchasing a Frontline RGSS58 This manual must 

4.  Installation, set-up, and use of Lifeline system must be done 

be read and understood in its entirety, and used as part of an 

under the supervision of a Qualified Person. 

employee training program as required by OSHA or any applicable 
state agency.

Installation and Use

This and any other included instructions must be made available to 

1. Eliminate all risk of lower end and termination. Either ensure 

the user of the equipment. The user must understand how to safely 

Vertical Lifeline Assembly(VLA) will prevent user from striking

and effectively use the RGSS58, and all fall safety equipment 

 next lower level and that there is always adequate fall clearance,

used in combination with the RGSS58.

 or that VLA will not reach the leading edge of any fall hazard 

when used at its full length. NEVER tie knot in lifeline, except 

Applicable Safety Standards

at extreme bottom of lifeline in order to prevent Fall Arrest from 

When used according to instruction specifications, this product 

2. Eliminate or minimize all risk of swing fall. 

meets or exceeds 

ANSI Z359.1-2007

 standards for fall protection. 

Applicable standards and regulations depend on the type of work 

3. Attach snap hook with integrated Shock Pack to compatible 

being done, and also might include state-specific regulations. 

anchorage connector.

Consult regulatory agencies for more information on personal fall 

4. Attach snap hook with integrated Fall Arrest to applicable 

arrest systems and associated components.

harness D-ring.

Worker Classifications

5. To move along lifeline, compress and hold Fall Arrest handle. 

Qualified  Person: 

A  person  with  an  accredited  degree  or 

ALWAYS adjust Fall Arrest to reduce slack in the system as 

certification,  and  with  extensive  experience  or  sufficient 

much as possible. When attached to a Fall Arrest and moving 

professional standing, who is considered proficient in planning and 

along work surface, ALWAYS do so by moving Fall Arrester 

reviewing the conformity of fall protection and rescue systems

along rope, and NEVER by moving only the rope itself. For 
example, if moving from a roof edge to the roof peak, engage 

Competent Person: 

A highly trained and experienced person who 

is ASSIGNED BY THE EMPLOYER to be responsible for all 

handle of fall Arrester and move it up the Vertical Lifeline Assembly

elements of a fall safety program, including, but not limited to, its 

(VLA) while walking to peak. DO NOT move up to roof peak by 

regulation,  management,  and  application.  A  person  who  is 

moving VLA and keep Fall Arrest stationary; doing so can create 

proficient in identifying existing and predictable fall hazards, and 

free fall in excess of levels permitted by system. 

who has the authority to stop work in order to eliminate hazards.

6. To restrict Fall Arrest movement along lifeline, release Fall 

Authorized Person: 

A person who is assigned by their employer to 

Arrest handle. 

work around or be subject to potential or existing fall hazards

7. Fall Arrester RGSS58 comes with an anti-panic feature which 

automatically acts in case the user holds the fall arrester and 

It is the responsibility of a Qualified or Competent person to 

grasps it too tightly. However, care must be taken that never 

supervise  the  job  site  and  ensure  all  applicable  safety 

grab fall arrester in the event of fall.

regulations are complied with.

8. NEVER work above the Fall Arrester unless free fall is limited to 

IMPORTANT  BEFORE INSTALLATION AND USE :-

6' or less.

Prior to use, plan your system:

WARNING: One connection per Vertical Lifeline Assembly(VLA). 

1.  Ensure  all  PFAS  equipment  is  selected  and  deemed 

NEVER attempt to remove components from VLA.  

compatible by a Competent Person.

2.  Eliminate or minimize all risk of swing fall.

Do not alter & misuse the equipment.

3.  Determine desired location for Lifeline; ensure location is free of 

Applicable to 

:

RGSS58

Manufacturer 

 

:

  

Certification Body 

SATRA Technology Centre Kettering, Northants, UK 
(Notified Body 0321)

Ongoing Assessment Body 

SGS United Kingdom Ltd., Unit 202B, Worle Parkway,
Weston-super-Mare, BS22 6WA, UNITED KINGDOM.  
(Notified Body 0120)

USER INSTRUCTIONS

Do not skip this instruction manual. Read the instruction manual carefully before using the equipment. If failed in doing so 
it may cause serious Injury or Death.

Page 1 of 4

RGSS58

Loosen the
Nut for Opening 
the Fall Arrester
Flange

Direction of Usege

Press the
safety clip
of the Fall 
Arrester

Direction of Usege

Direction of Usege

Rope

Fall Arrester

Follow these steps to install the Fall Arrester

detaching. 

Отзывы: