5
Waste Oil Caddy |
Frontline International Inc
.
PROBLEM
PROBABLE CAUSE
CORRECTIVE ACTION
Caddy motor will not run.
The caddy motor is not
turned ON.
Turn the motor ON with the switch located on the back of the
motor.
Caddy motor reset switch
has tripped.
Press the motor reset switch on the back of the caddy motor.
The caddy power cord
is not making proper
connection.
Ensure the caddy power cord is completely plugged into the
motor and the control panel receptacle .
The tank or control panel
at the fill station has lost
power.
Ensure the tank or fill station control panel are plugged in.
Ensure the outlet that the tank or fill station control panel is
plugged into has not lost power.
If there is no power to the outlet make sure the circuit breaker
has not tripped or that the outlet is not on a switch that has
been turned off.
Caddy motor runs but no
oil will pump.
Disconnect fittings are not
properly connected.
Make sure the female disconnect fitting is properly connected
to the male fitting.
Caddy hose may be
plugged with grease.
Run the caddy hose under hot water to liquefy any grease that
may be clogging the hose.
Caddy pump may be
plugged with grease.
Remove the four screws on the front of the pump and clean the
inlet and outlet port of the pump, and the rotor gear.
Make sure that nothing is blocking the inlet tube that goes
down into the oil.
Assure that the oil being discarded is in liquid state.
Call 330-861-1100 if you have checked all of the above and the problem still has not been resolved.
Troubleshooting
See the following table to troubleshoot problems
