Frontier ST1332, Руководство оператора

Страница: 13 / 60

ASSEMBLY
13
MTF − 051059L
UPPER HANDLE ASSEMBLY
1. Cut tie holding shift rod to lower handle and move shifter
to the neutral position.
2. The fasteners that secure the upper handle to the lower
handle are mounted in the handles. Loosen, but do not
remove these fasteners (see See Figure 5).
3. The remaining fasteners are mounted in either the upper
handle or the lower handle . To allow the handle to be
raised to the operating position, remove these fasteners.
4. Raise upper handle to the operating position. The upper
handle must be to the outside of the lower handle .
NOTE: Make sure the cables are not caught between
the upper and lower handles.
NOTE: If the cables have become disconnected from
the drive levers, reinstall the cables as shown in
Figure 6.
5. Install the fasteners that were removed in step 3. DO
NOT tighten until all bolts are in place.
6. Tighten all handle bolts.
Figure 5
Nut
Flatwasher
Bolt
Lockwasher
Lower Handle
Upper Handle
Figure 6
Lever
“Z” Fitting
Control Cable
CHECK THE CABLES
If control cables have become unattached from motor mount
frame, reconnect cables as shown in Figure 7.
Traction Drive Cable
Auger Drive Cable
Figure 7
HOW TO SET
THE LENGTH OF THE CABLES
The cables were adjusted at the factory and no adjustments
should be necessary. However, after the handles are put in
the operating position, the cables can be too tight or too
loose. If an adjustment is necessary, see “How To Check And
Adjust The Cables” in the Maintenance section.