Frontier ST0726, Руководство оператора

Страница: 15 / 60

OPERATION
15
MTF-0410104L
HOW TO REMOVE SNOW FROM AUGER
WARNING: Do not attempt to remove snow or
debris that may become lodged in auger with-
out taking the following precautions:
A cleaning stick is attached to the top of the auger housing.
Use the cleaning stick to remove snow from the auger
housing.
Release auger drive lever.
Move throttle lever to stop position.
Remove (do not turn) ignition key.
Disconnect spark plug wire.
Do not place your hands in the auger or discharge
chute. Use the cleaning stick to remove snow.
HOW TO USE THE WHEEL LOCKOUT
The wheel is secured to the axle with a lockout pin. See
Figure 14. The unit was shipped with the lockout pin in the
locked position. For ease of maneuverability, disconnect the
lockout pin as follows.
1. Pull the
knob out to disengage the lockout pin.
2. To lock in the disengaged position, turn the knob 1/4 turn
(90 degrees).
Figure 14
ÁÁÁ
ÁÁÁ
ÁÁÁ
ÁÁÁ
Á Á
Knob
Wheel Lockout
HOW TO SET THE DRIFT CUTTERS
(OPTIONAL ACCESSORY ON SOME MODELS)
Drift cutters are used to cut a path through snow deeper than
the auger housing.
1. Loosen the
wingnuts that secure the drift cutters to the
auger housing (see Figure 15).
2. Raise the drift cutters to the desired height.
3. Tighten the wingnuts.
Drift Cutter
Wingnut
Figure 15