Frontier RB1172, Руководство оператора

Страница: 10 / 24

10 Operation
5WPMAN0148 (Rev. 5/16/2008)
Adjust sway blocks or tighten tractor 3-point sway
chains to eliminate implement side-to-side movement
during operation.
Figure 2 . Top Link Identification
Optional Quick Hitch Bushing Kit
An optional quick hitch bushing kit is available for Cate-
gory 1 and Category 2 tractors. See page 14 for instal-
lation instructions.
NOTICE
„
Do not use Quick Hitch with Single Tailwheel
Kit.
Parking Stand Placement
Operating Position
Place parking stand in the raised position during opera-
tion. This position allows the moldboard to rotate 360
degrees. Secure into position with 3/8 x 2-1/4 lynch pin
as shown in Figure 3.
Figure 3 . Parking Stand In Raised Position
Storage Position
With rear blade raised, place parking stand in lowest
position as shown in Figure 4. Lower rear blade so cut-
ting edge and parking stand are flat on the ground. Dis-
connect 3-point arms and top link from rear blade.
Figure 4 . Parking Stand in Storage Position
ADJUSTMENTS
„
NEVER GO UNDERNEATH EQUIPMENT. Never
place any part of the body underneath equipment
or between moveable parts even when the engine
has been turned off. Hydraulic system leak-down,
hydraulic system failures, mechanical failures, or
movement of control levers can cause equipment
to drop or rotate unexpectedly and cause severe
injury or death.
• Service work does not require going under-
neath.
• Read Operator's Manual for service instruc-
tions or have service performed by a qualified
dealer.
Adjustments to the rear blade require raising the blade
slightly off of the ground. Do not leave the tractor oper-
ator position with the blade raised except to make
blade adjustments during operation.
To make blade adjustments, raise the blade just high
enough to allow blade to pivot without dragging on the
ground. Shut off the tractor engine, set the park brake,
remove the key, and carefully leave the operator posi-
tion.
Never place any part of your body underneath the
blade or 3-point hitch while making adjustments.
Hydraulic leak-down or failure can cause the blade to
fall suddenly.
WARNING