Frontier FMC100, Руководство пользователя

Страница: 8 / 37

Correct Disposal of this product
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent
possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources.
Champion ®
Makadamgatan 14 I 254 64 Helsingborg I Sweden
info@championnordic.se
Designed in Sweden I Assembled in China
Care & Maintenance
As with all mechanical equipment, we recommend checking all parts that may become loose with use. Check all parts of the bike,
concentrating on screws, nuts, seat, pedals and caps, making sure they are still tight and functioning correctly. Any parts found to
be not functioning correctly or found to be loose must be corrected before next using the bike. The parts should be checked on a
regular basis every 2 to 4 weeks, depending on how often you use the bike. For you own safety, look over the bike prior to each
use so you are sure it is safe to use. This avoids possible injuries because of loose or defective parts.
Failure to check the Machine for loose or defective parts could result in injury or damage to the machine. If you want to clean the
Machine, use only very mild detergents. Do not use any cleaning products containing bleach or ammonia, as these will damage the
surface finish.
Please pay attention that no liquids are allowed to enter the inner parts of the Rower or the computer, as this may lead to defects.
When exercising, please take care that no perspiration drips off you as you exercise, as it can cause damage to plastic and metal
surfaces.
Trouble shooting guide
1. Verify that all the bolts and nuts are locked properly and the turning parts should be turned freely without damaged parts.
2. Clean the equipment with soap and slightly damp cloth only. Please do not use any solvent to clean the equipment.
Problem Potential cause Corrections
Base is unstable. 1. Floor is not flat or there is small object
under the front or rear stabilizer.
2. The rear stabilizer end caps have no
been leveled when adjusting
1. Remove the object.
2. Adjust the rear stabilizer end
caps.
Handlebar is shaking. The bolts are loose. Tighten the bolts.
Loud noise from the moving parts. The interval of the parts is improper tighten. Open the covers to adjust.
No resistance when riding the bike. 1. The interval of the magnetic resistance
increases.
2. Tension control knob is damaged.
3. Belt slips.
4. The bearing set is damaged.
1. Open the covers to adjust.
2. Change the tension control
knob.
3. Open the covers to adjust.
4. Change the bearing set.
EN