Note 1 :
It is also possible to listen to only the Left or Right audio channel using only the speaker
set. To do so, simply set the switch on the speaker's back panel to LEFT or RIGHT. Only the
channel selected will be audible.
Note 2 :
If two speakers are connected to the system, ensure both speakers are placed within the
effective operational range. If either speaker is out of range it will cause distortion to both
speakers.
AUX In
To connect an audio device directly to the speaker, insert the output audio cable from the device into
the AUX In jack located on the back panel of the speaker.
Note :
−
If the source signal is too weak for reception, the transmitter automatically switched off after
approximately 4 minutes to protect the unit and save power. If the source signal returns to an
adequate level, the transmitter automatically switches back on.
−
When the transmitter is in Standby mode, the speaker automatically switches off after
approximately 20 minutes to protect the unit and save power.
−
To switch speaker power back on during Standby mode, press the POWER button on the remote
control. The signal link between the transmitter and speaker reconnects automatically.
Troubleshooting
No sound
−
Ensure the AC adapter is securely plugged into the wall outlet and the transmitter DC IN jack.
−
Ensure the speaker POWER button is in the ON position.
−
Speaker batteries may be too weak. Replace with new batteries or connect with the included
ac/dc adapter.
−
Ensure the connected audio device is switched on and producing a signal.
−
Ensure that the volume level is set to a moderate level.
−
Redo the pairing process by pressing the “Pair” button on the speakers and transmitter
simultaneously.
Distortion
−
Speaker batteries may be too weak, Replace with new batteries or connect with the included
ac/dc adapter.
−
Ensure that the volume level is set to a moderate level.
−
The speakers are too far from the transmitter. Move closer to the transmitter base.
−
The audio input signal may be too low : increase the volume level of the audio source.
−
If two speakers are connected to the system, ensure both speakers are placed within the effective
operational range. If either speaker is out of range it will cause distortion to both speakers.
