205mm
1265mm
1370mm
TOP OF THE WINDSCREEN
REMOVE
75mm
© 2022 FRONT RUNNER VEHICLE OUTFITTERS
4
KSFR002_REV_A03
FIT AND SECURE
2
13mm
2.13
2.14
2.15
Drill the 8 holes you marked earlier,
starting with a 4mm pilot hole before
going to the 6mm hole. There is no need
for a lot of downward pressure. Let the
drill do the work.
Starting at the top edge of the vehicle's
windscreen, measure and mark the
dimensions as shown onto both of the LH
& RH ditch trim pieces.
Remove the two trim pieces and cut on
each of your markings. Make sure to mark
the various pieces so that you are able to
place them back in their correct positions.
Refit the ditch trim pieces in place using
double sided tape NOT SUPPLIED.
Make sure the ditch & trim is clean before
applying the tape.
Remove the two trim pieces.
Starting at the top edge of the vehicle's
windscreen, measure and mark the
dimension as shown onto both LH / RH
ditch centre's.
Place the foot rail on the vehicles roof
lining up the front slot centre with the
mark you made and mark the centre of the
remaining 3 slots. Do this on both the LH &
RH side.
Before drilling into the vehicle assemble
the Slimsport rack and place it on the
vehicle to check for antenna clearance get
a friend to help you (2.16).
Apply anti-rust to all the holes drilled.
MODELS WITHOUT FACTORY MOUNTED RAILS
DITCH TRIM OPTION
NO TRIM OPTION
90mm