Front Runner RRAC189, Инструкции по сборке и монтажу

Страница: 3 / 4

RRAC189_REV_A00 3 © 2021 FRONT RUNNER VEHICLE OUTFITTERS
FIT AND SECURE
2
4MM
2.1
2.2
2.3
13MM
13MM
Mounting to a SLII Rack
Mounting to a Load Bar
10MM
8
8
11
9
10
12
1
9
10
Assemble the Quick Release 9mm Insert to
the Thru Axle Bracket (Item 2 & 3) as shown
in fig 1.1. Decide where you want to mount
your bicycle on the rack. Figure out the
correct spacing between the fork and rear
wheel. To fit the Thru Axle Extrusion (Item
2), slide two M8 x 20 Hex Bolts (Item 5) into
the T-slot of the choosen slat. Place the Thru
Axle Bracket (Item 2) over the two Hex bolts
and secure to the rack using two M8 Nyloc
Nuts (Item 6) This will apply to Load Bars
as well. Mount the Rear Wheel Mounting
Bracket (Item 1) to a slat / combined slat as
shown. Slide two M8 x 20 Hex Bolts (Item 5)
into the chosen slat / combined slat. place
the Bracket over the Hex Bolts and line up
the Bracket with the center of the Thru Axle
Bracket. Secure the Rear Wheel Bracket to
the rack using M8 Nyloc Nuts (Item 6). Place
M8 Nut caps over all Hex Bolts.
Assemble the Quick Release 9mm Insert to
the Thru Axle Bracket (Item 2 & 3) as shown
in fig 1.1. Figure out the correct spacing
between the fork and rear wheel. To fit the
Thru Axle Extrusion (Item 2), slide two M8
x 20 Hex Bolts (Item 5) into the T-slot of the
choosen slat. Place the Thru Axle Bracket
(Item 2) over the two Hex bolts and secure
to the Load Bars using two M8 Nyloc Nuts
(Item 6). Mount the Rear Wheel Mounting
Bracket (Item 1) to the rear slat as shown.
Slide two M8 x 20 Hex Bolts (Item 5) into
the front slat. Place the Bracket over the
Hex Bolts and line up the Bracket with the
center of the Thru Axle Bracket. Secure the
Rear Wheel Bracket to the Load Bars using
M8 Nyloc Nuts (Item 6). Place M8 Nut caps
over all Hex Bolts.
If the Strap (Item 12) needs to be length-
ened, use the Angle Bracket (Item 11).
Loosen the Strap and secure the Angle
Bracket to the Rear Wheel Mounting Bracket
(Item 1) using the existing fasteners.
Secure the Strap to the Angle Bracket
(Item 11) using M6 x 16 Button Head and
M6 Nyloc Nut (Items 8 & 9).
Place M6 Nut Caps (Item 10) over all M6
Nyloc Nuts.
5
2
6
7
5
6
7
1
5
2
6
7
5
1
6
7