RRAC148_REV_A01
© 2018 FRONT RUNNER VEHICLE OUTFITTERS
3
FIT AND SECURE
2
2.1
2.2
2.3
Before starting the fitment, remove the Clamp
from the Bike Carrier (Item 1) by loosening
the M8 Eye Nut (Item 10) as shown in Figure
1.1.
Decide where you'd like to mount your bike
on the Rack.
Fit the Bike Carrier (Item 1) by sliding four
M8 x 20 Hex Bolts (Item 8) into the machined
slots of the chosen slats. Place the Bike
Carrier over the four Hex Bolts and secure
to the Rack using four M8 x 16 x 1.6SS Flat
Washers and four M8 Nyloc Nut (Items 6 & 7)
as shown.
Note: The shorter arm on the carrier should
always be at the back.
Finish off by placing M8 Nut Caps over the
Nyloc Nuts.
Remove your bike from the Bike Carrier.
Lower the two arms. Find an open slat to
secure the Bottom Clamp (Item 2). Slide two
M8 x 20 Hex Bolts into the machined slots
of the chosen slat. Secure the Bottom Clamp
using M8 x 16 x 1SS Flat Washers and M8
Nyloc Nuts (Items 6 & 7) as shown.
Finish off by placing M8 Nut Caps on the
Nyloc Nuts.
When the Bike Carrier is not in use, lower
the arms and secure them using the Top
Clamp (Item 3), M8 Eye Nut and M8 Nylon
Washer (Items 9 & 10).
7
6
5
1
8
Adjustable
Wheel Stop
Knob
Center The Wheel On The Base
To set the carrier mount for your bike, make
sure that the Front Arm is opened all the
way.
Place the bikes front wheel into the Bike
Carrier.
Center the wheel on the base of the Carrier
and lower the Adjustable Wheel Stop against
the front of the wheel. Fully tighten the three
button head bolts of the Adjustable Wheel
Stop.
Lift the Rear Arm up against the back of
the wheel and apply slight pressure while
turning the Adjusting Knob to clamp the
wheel firmly in place.
Rear
Arm
Front
Arm
13mm
13mm
4mm
3
9
10
3
7
6
5
8