Front Avenue Front Avenue 463269806, Руководство по эксплуатации продукта

Страница: 8 / 28

Burner Flame Check
• Remove cooking grates and flame tamers. Light burners, rotate
knobs from HIGH to LOW . You should see a smaller
flame in LOW position than seen on HIGH. Perform burner
flame check on sideburner, also. Always check flame prior to
each use. If only low flame is seen refer to "Sudden drop or low
flame" in the
. Troubleshooting Section
HIGH
LOW
8 • 463269806
Turning Grill Off
Ignitor Check
Valve Check
Hose Check
General Grill Cleaning
• Turn all knobs to position. Turn LP cylinder off by
turning hand-wheel clockwise to a full stop.
Press and hold electronic ignitor
button. "Click" should be heard and spark seen each time
between collector box or burner and electrode. See
if no click or spark.
. Knobs lock in position. To check
valves, first push in knobs and release, knobs should spring
back. If knobs do not spring back, replace valve assembly
before using grill. Turn knobs to
position then turn back to
position. Valves should turn smoothly.
Before each use, check to see if hoses are cut or worn.
Replace damaged hoses before using grill. Use only
valve/hose/regulator specified by manufacturer.
• Do not mistake brown or black accumulation of grease and
smoke for paint. Interiors of gas grills are not painted at the
factory
. Apply a strong solution
of detergent and water or use a grill cleaner with scrub brush
on insides of grill lid and bottom. Rinse and allow to completely
air dry.
• Wash with warm soapy water and wipe dry.
Do not use citrisol, abrasive cleaners, degreasers or a
concentrated grill cleaner on plastic parts. Damage to and
failure of parts can result.
Because of glass-like composition, most
residue can be wiped away with baking soda/water solution or
specially formulated cleaner. Use nonabrasive scouring powder
for stubborn stains.
Wash with mild detergent or nonabrasive
cleaner and warm soapy water. Wipe dry with a soft
nonabrasive cloth.
To maintain your grill’s high quality
appearance, wash with mild detergent and warm soapy water
and wipe dry with a soft cloth after each use. Baked-on grease
deposits may require the use of an abrasive plastic cleaning
pad. Use only in direction of brushed finish to avoid damage.
Do not use abrasive pad on areas with graphics.
• Turn gas off at LP cylinder.
• Important: Make sure gas is off at LP cylinder before
checking valves
LOW
•
(and should never be painted)
Do not apply a caustic grill/oven cleaner to painted
surfaces.
Plastic parts:
• Porcelain surfaces:
• Painted surfaces:
• Stainless steel surfaces:
"Troubleshooting"
s
OFF
OFF
OFF
Sideburner Ignitor Lighting
Sideburner Match Lighting
s
Turn on gas at LP cylinder.
Turn sideburner knob to HIGH , push and hold
ELECTRONIC IGNITOR button.
If sideburner does NOT light, turn knob to OFF
, wait 5
minutes, then repeat lighting procedure.
Turn on gas at LP cylinder.
Place lit match near burner.
Turn sideburner knob to HIGH .
Be sure burner lights and
stays lit.
Do not lean over grill while lighting.
1. Open sideburner lid.
2.
3.
1. Open sideburner lid.
2.
3.
CAUTION
If ignition does NOT occur in 5 seconds, turn the
burner controls OFF, wait 5 minutes and repeat the
lighting procedure. If the burner does not ignite with
the valve open, gas will continue to flow out of the
burner and could accidently ignite with risk of injury.
Match-Lighting
s
Do not lean over grill while lighting.
1. Open lid.
2.
3.
4.
Turn on gas at LP cylinder.
Place lit match into match holder (hanging from cart side
panel), then into lighting hole on right or left side of grill.
Push in and turn far right or far left burner knob to HIGH .
Be sure burner lights and stays lit.
Light adjacent burners in sequence by pushing knobs in and
turning to HIGH
.
Turn controls and gas source or tank OFF when not
in use.
WARNING