Fronius Virtual Welding 2.0, Руководство по эксплуатации

Страница: 35 / 152

35
EN
-U
S
Assemble and
screw in the
StandUp Terminal
Place the bottom part in its final setup
location
- To do so, make sure that the
mounting brackets (2) extend to
the wall
Place the top part on the bottom part
Screw the two parts together using the
4 M8 x 80 mm Allen screws (1) sup -
plied
Screw the StandUp Terminal onto the
mounting brackets (2) on the wall
- Wall mounting material is not in -
cluded in the scope of supply. The
installer is responsible for selec -
ting the proper mounting materi -
als.
Tighten the 4 M8x16 mm screws (3) on
the mounting brackets
Screw the StandUp Terminal through
the holes (4) to the floor
- The mounting material for fixing to
the floor is not included in the sco -
pe of supply. The installer is re -
sponsible for selecting the proper
mounting materials.
Loosen the screws (5) while holding one of the brackets (6)
Guide the brackets (6) down until the screws (5) can be screwed through the holes (7)
Fasten the screws (5)
(2)
(1)
(4)
(2)
(3) (3) (3) (3)
(4)
1
2
3
4
5
6
(5) (6) (6) (5)
(5)
(6)
(7)
(6)
(7)
(5)
7
8
9