Service, maintenance and disposal
General
Under normal operating conditions, the welding system requires only a minimum
of care and maintenance. However, several points must be observed in order for
the welding system to remain operational for years to come.
Safety
WARNING!
Danger from electrical current.
This can result in serious personal injury and damage to property.
▶
Before starting work, switch off all devices and components involved, and
disconnect them from the grid.
▶
Secure all devices and components involved so they cannot be switched back
on.
▶
After opening the device, use a suitable measuring instrument to check that
electrically charged components (such as capacitors) have been discharged.
WARNING!
Danger from incorrect operation and work that is not carried out properly.
This can result in serious personal injury and damage to property.
▶
All the work and functions described in this document must only be carried
out by technically trained and qualified personnel.
▶
Read and understand this document in full.
▶
Read and understand all safety rules and user documentation for this equip-
ment and all system components.
At every start-
up
-
Check mains plug and mains cable, as well as the welding torch, intercon-
necting hosepack, and ground earth connection for damage
-
Check if the all-round clearance of the device is 0.5 m (1 ft. 8 in.) so that
cooling air can circulate unimpeded
NOTE!
Air inlet and outlet openings must not be blocked or even partially covered.
Every 2 Months
CAUTION!
Danger of damage to property.
▶
The air filter must only be fitted when dry.
▶
If required, clean air filter using dry compressed air or by washing it.
118
Содержание TransSteel 4000 Pulse
