Fronius Robacta TC 2000, Инструкция по эксплуатации и запасные части

Страница: 44 / 72

44
Filling the dipping bowl with parting agent
Filling the dipping
bowl with parting
agent
Fold out the container holder containing the empty "Robacta TC Cool / Robacta TC
Cool MD" parting agent container
Remove the empty "Robacta TC Cool / Robacta TC Cool MD" parting agent container
and dispose of it according to national regulations
Open a new "Robacta TC Cool / Robacta TC Cool MD" parting agent container and
put it into the holder
Fold the container holder containing the full "Robacta TC Cool / Robacta TC Cool MD"
parting agent container carefully back above the dipping bowl
- The optimum fill-level is regulated automatically
NOTE! Only use the "Robacta TC Cool / Robacta TC Cool MD" parting agent sup-
plied by the manufacturer. The composition of the manufacturer's parting agent is
intended specifically for the Robacta TC. If other manufacturers' products are
used, trouble-free operation cannot be guaranteed.
1
2
3
4
NOTE! Carry out the following maintenance on the dipping bowl at weekly inter-
vals:
-
Take the spill tray out of the dipping bowl and dispose of any accumulated dirt
- Check the consistency of the "Robacta TC Cool / Robacta TC Cool MD" part-
ing agent. If the "Robacta TC Cool / Robacta TC Cool MD" parting agent is
thick, add fresh water and stir to mix in
- Check the level sensor in the dipping bowl for dirt and clean if necessary
NOTE! Carry out the following maintenance on the dipping bowl every three
months:
-
Drain all the parting agent from the dipping bowl
- Take the spill tray out of the dipping bowl and dispose of any accumulated dirt
- Clean the dipping bowl and spill tray
- Fill the dipping bowl with new parting agent
Take care never to damage the level sensor when performing maintenance work.
3 4 2 1