Fronius Robacta Reamer V, Руководство по эксплуатации

Страница: 38 / 104

Ensuring that the
cleaning device
is depressurised Attempt to briefly activate the cleaning device without any compressed air supply to
check whether the cleaning device is depressurised. Proceed as follows:
1
Take protective measures:
-
The cleaning cutter, lifting device, gas nozzle clamping device, wire cutter and
parting-agent injection nozzle could start up. Therefore keep your body, espe-
cially your hands, face and hair, any objects and all clothing away from the com-
ponents referred to above
- Wear ear protection
- Wear protective goggles with side protection
2
Ensure that the cleaning device has been disconnected from the compressed air
supply
Robacta Reamer V Easy and Robacta Reamer V Easy Han6P J:
3
Briefly turn the "Cleaning" screw on the cleaning device 90° to the right, then turn it
straight back to its original position
- If the cleaning device does not respond to the turning of the screw, the cleaning
device is depressurised
- If the cleaning device responds to the turning of the screw, the cleaning device is still
connected to a compressed air supply.
If this is the case, you must disconnect the cleaning device from the compressed air
supply and check again that the cleaning device is depressurised before starting
work
Robacta Reamer V:
3
Briefly turn the "Lifting device up/down" screw on the cleaning device 90° to the right,
then turn it straight back to its original position
- If the cleaning device does not respond to the turning of the screw, the cleaning
device is depressurised
- If the cleaning device responds to the turning of the screw, the cleaning device is still
connected to a compressed air supply.
If this is the case, you must disconnect the cleaning device from the compressed air
supply and check again that the cleaning device is depressurised before starting
work
38