12
Commissioning,
maintenance and
repair
Safety inspection
Safety symbols
If any damage occurs in cases where other cleaning agents have been used,
the manufacturer shall not be liable for any such damage, and all warranty
claims shall be null and void.
Only transport the cleaning agent in closed original containers.
It is impossible to guarantee that bought-in parts are designed and manufac
-
tured to meet the demands made of them, or that they satisfy safety require
-
ments.
-
Use only original spare and wearing parts (also applies to standard
parts).
-
Do not carry out any modifications, alterations, etc. to the device without
the manufacturer's consent.
-
Components that are not in perfect condition must be replaced immedi
-
ately.
-
When ordering, please give the exact designation and part number as
shown in the spare parts list, as well as the serial number of your device.
The housing screws provide the ground conductor connection for earthing
the housing parts.
Only use original housing screws in the correct number and tightened to the
specified torque.
The manufacturer recommends that a safety inspection of the device is per
-
formed at least once every 12 months.
The manufacturer recommends that the power source be calibrated during
the same 12-month period.
A safety inspection should be carried out by a qualified electrician
-
after any changes are made
-
after any additional parts are installed, or after any conversions
-
after repair, care and maintenance has been carried out
-
at least every twelve months.
For safety inspections, follow the appropriate national and international
standards and directives.
Further details on safety inspection and calibration can be obtained from
your service centre. They will provide you on request with any documents
you may require.
Devices with the CE mark satisfy the essential requirements of the low-volt
-
age and electromagnetic compatibility directive (e.g. relevant product norms
from the EN 60 974 series).
Devices with the CSA test mark satisfy the requirements of the relevant
standards in Canada and the USA.
