Fronius Energy Package, Руководство по эксплуатации, Страница: 133 / 148

Fronius Solar Battery
Status code dis-
play The storage system performs a system self-diagnosis that automatically detects
many faults that may occur. These are indicated on the display or via LEDs. This
means you are promptly made aware of malfunctions in the storage system, or of
any installation or operating faults.
If the system self-diagnosis has detected a specific fault, the associated status
code will be shown on the display.
Error messages
– Battery man-
agement module
Indicator Details Solution
NO MODULE No module Connect modules
If modules are connected The message on the left
appears even if modules
are connected. Check
whether they have been
connected properly.
OV Error Overvoltage Discharge
DISCHARGE
ERR Deep discharge Charge
COMM ERR
or CON=
-------------
ooox Error affecting communication
with connected modules. The ex-
ample on the left illustrates a
scenario in which one module
(no. 00) is affected by a commu-
nication error, 3 modules (nos.
01, 02 and 03) are connected
and the other addresses are
without a connection.
COMM OFF
MODE For maintenance only
No informa-
tion displayed Wiring error, storage module ad-
dressing error or system-critical
error Check wiring, check ad-
dress settings for individu-
al storage modules
Error message –
Data converter If the data converter detects an error, the “State” LED lights up steady red to
signal that an error has occurred. At the same time, the associated error mes-
sages are displayed via the “Error No” LEDs in accordance with table below.
There are two different error categories:
Serious errors (1 - 5): In this case, the data converter has to be switched off and
then back on again. If the error recurs, the data converter must be replaced and
sent away for repair.
Warnings (6 - 15): These warnings are displayed for information only. They appear
for 1 minute and are then reset automatically. If these warnings occur quite fre-
quently, Customer Services should be notified accordingly.
These displays are not applicable in Configuration mode and are intended for in-
ternal purposes only.
133
EN