34
Welding parameter standard values
Alignment of
welding torch rel
-
ative to the work
-
piece for fillet
welds
Side view of welding torch/workpiece
-
Align welding torch (1) relative to the
workpiece (2) as shown on the left-
hand figure
-
Welding torch (1) at a 5° angle to the
welding direction
Alignment of
welding torch rel
-
ative to the work
-
piece for lap
joints
Side view of welding torch/workpiece
-
Align welding torch (1) relative to the
workpiece (2) as shown on the left-
hand figure
-
Welding torch (1) at a 5° angle to the
welding direction
NOTE!
If notches appear in the weld seam on the top sheet, adopting the welding torch
alignment shown below can prevent these notches from occurring.
35 - 40°
(1)
(2)
55 - 75°
(1)
(2)
Содержание Drive EasyTwin
